CERAMIC DRY LUBE

APPLICATION - INSTRUCTIONS FOR USE
In the first application it is very important that all parts of transmission (chain, sprockets and derailleurs) are clean and dry, without oil residues or dirt. Thus we get the product to adhere properly. In later applications, we can relubricate until we have to clean it again. SHAKE IT WELL BEFORE USE.
The first application must be generous, let it dry and reapply after a few minutes.
Never use it before pedaling. If we go on route before the product dries, it will be lost quickly. We should establish a margin of over one hour.
Its duration depends on the type of use that we give it (running time of the route, weather conditions, state of transmission).

LUBE FORKS - SPRAY

APPLICATION - INSTRUCTIONS FOR USE
Before the application it will have cover the brake discs to avoid his pollution (.. or to go with a lot of care), to withdraw the dirt of the bars and the external part of the shaft seals.
TO SHAKE WELL BEFORE USING. (As all the Sprays). To pulverize from a distance of 20-30 cms.
To apply the thin cap of the product directly on the clean bars of the fork (or absorber) in all his circumference near the shaft seals, to compress several times and to clean if it has provoked ring dirt. To return to lubricate of the same way.

LUBE CERAMIC OIL

APPLICATION - INSTRUCTIONS FOR USE
In the first application it is very important that the zone to lubricating is clean well and dry, without residues of oil and dirt. This way we achieve that the Ceramics and the product stick fast correctly.
that the Ceramics and the product stick fast correctly. After applying the product, waiting a few minutes and cleaning the excess. TO SHAKE WELL BEFORE USING. (As all the Sprays)
The duration will depend wherefrom we it apply and on the type of use that (time of the route, climatic conditions, condition of the transmission or pieces etc).

DEGREASER CLEANER

APPLICATION - INSTRUCTIONS FOR USE
TO SHAKE WELL BEFORE USING. (As all the Sprays)
A distance supports of pulverized from 20 to 30 cms. for the splashes that could arise.
To use the product in pressures short and repeated on the surface to cleaning, to stop operate the product and to repeat if it is necessary.
The product does not need dried though we can clean cloth or to give air to accelerate the result.

LUBE CERAMIC GREASE

APPLICATION - INSTRUCTIONS FOR USE
In the first application it is very important that the zone to lubricating is clean well and dry, without residues of oil and dirt. This way we achieve that the Ceramics and the product stick fast correctly.
After applying the product, waiting a few minutes and cleaning the excess. TO SHAKE WELL BEFORE USING. (As all the Sprays)
The duration will depend wherefrom we it apply and on the type of use that (time of the route, climatic conditions, condition of the transmission or pieces etc).